Many people love lace front wigs for their versatility and believability. The lace at the front mimics a Brazilian Hair, allowing you to pull the wig away from your face in variety of hairstyles. Applying a lace front wig is easy and fast. First, flatten your hair and prepare your skin. Next, make adjustments to the wig such as tightening straps and trimming the lace. Last, apply any adhesive or wig tape and pull on your wig. Once your wig is perfectly arranged, you can style it any way you'd like!
1.Test the fit of the wig. Before you apply any adhesives, you need to make sure the wig fits properly. To do so, place the wig on your head and line it up with your 360 Lace Frontal. If the wig has tightening straps on the inside, you may need to adjust these for a proper fit.If you can feel a strong ring of pressure around your scalp, the wig is too tight. Loosen the straps slightly.If the wig slides around when you move your head, the wig is too loose. Tighten the straps.
2.Trim the lace. Once your wig fits properly, you need to trim the lace. Use a few clips to pull the hair away from your face. Next, using sharp pinking shears, trim the lace along your natural hairline. You should leave about 1/8 inch (3 mm) of lace. This will only have to be done the first time you wear the Human Hair Wigs.
3.Remove the wig and set it aside. Carefully pull the wig off, leaving all the clips in, and set the wig on a clean flat surface. Arrange the wig so that it’s easy to see what part goes on the hairline and what part goes on the nape of the neck.
4.Apply wig tape. Cut six to ten small pieces of wig tape. Next, line your hairline with the small pieces of tape by pressing the sticky side against your skin. Use a mirror while you do this to create an even hairline.Once the tape is applied, remove the thick foam padding to reveal the other side of the tape.
5.Use a liquid adhesive. If you don’t want to use wig tape, you can use a liquid lace adhesive instead. Use a clean makeup brush to apply the adhesive in thin line along your entire hairline.Depending on the type of adhesive, you may need to wait a few minutes before wearing your wig.
6.Apply the wig. Carefully pull the wig on. First, adjust the edge of the wig so that the hairlines match. Next, adjust the back of the wig so that it hangs naturally over your hair. Lastly, press the lace of the wig into your adhesive or wig tape.